+86 135 3053 5995
sales@mydled.comWe use our own and third-party cookies to ensure the proper functioning of the web portal and its complements, perform navigation analysis and show multimedia content. If you continue browsing, you accept the use of this technology. For more information please see our Cookies Policy. Learn more
1. switch electronic LED display notes:
1) Switching sequence:
When opening the screen: first turn on the screen, then open the screen.
When closing the screen: first turn off the screen, then turn off the screen.
(The computer does not turn off the display first, which will cause the screen to appear bright, burning the lamp, the consequences are serious.)
2) The interval between switch screens should be greater than 5 minutes.
3) After the computer enters the engineering control software, it can be powered on.
4) Avoid opening the screen in the full white screen state because the system has the largest inrush current.
5) Avoid opening the screen in an out of control state because the system has the largest inrush current.
A. the computer does not enter the control software and other programs;
B. the computer is not powered;
C. The control part is not turned on.
6) When the ambient temperature is too high or the heat dissipation conditions are not good, care should be taken not to open the screen for a long time.
7) When a part of the electronic display body appears very bright, it should be noted that the screen should be turned off in time, and it is not suitable to open the screen for a long time in this state.
8) The power switch of the display often trips. Check the screen or replace the power switch.
9) Regularly check the tightness of the hook. If there is looseness, pay attention to timely adjustment, re-reinforce or update the hanger.
10) According to the environment of the large screen display screen and control part, avoid insect bites, and place anti-rat medicine if necessary.
2. Changes in the control part and changes in the precautions
1) The power cord of the computer and control part is zero and the fire cannot be reversed. It should be inserted in the original position strictly. If there are peripherals, after the connection is completed, the chassis should be tested for power.
2) When controlling the computer and other control equipment, first check the connection line and the control board for looseness before power-on.
3) The position and length of the communication line and flat connection line cannot be changed at will.
4) If abnormalities such as short circuit, tripping, burning line, and smoke are found after moving, the power should not be tested repeatedly. The problem should be found in time.
3. software operation and use precautions
1) Software backup: WIN2003, WINXP, application, software installation program, database, etc. It is recommended to use the "One Click Restore" software for easy operation.
2) Proficiency in installation methods, raw data recovery, and backup.
3) Master the setting of control parameters and the modification of basic data presets.
4) Skilled use of procedures, operations and editing.
5) Check the virus regularly and delete irrelevant data.
6) For non-professionals, do not operate the software system.