EN CN

+86 135 3053 5995

sales@mydled.com
CN

We use our own and third-party cookies to ensure the proper functioning of the web portal and its complements, perform navigation analysis and show multimedia content. If you continue browsing, you accept the use of this technology. For more information please see our Cookies Policy. Learn more

News

Attention Points of Full Color LED Display (Part Two)

2018-11-27 www.myddisplay.com

LED display like other items, inevitably encounters problems and precautions in use.


Meiyad P3 Indoor Full Color LED Display


5. Mix the lamp


LEDs of the same color with different brightness levels need to be mixed, or inserted into the light pattern according to the discrete pattern to ensure the consistency of the brightness of each color of the whole LED screen. If there is a problem in this process, the local brightness of the LED display will be inconsistent, which will directly affect the display effect of the LED display.


6. Control the perpendicularity of the lamp


For DIP LEDs, there must be enough process technology to ensure that the LEDs are perpendicular to the PCB. Any deviation will affect the brightness consistency of LEDs already had been set, and the color blocks with inconsistent brightness will appear.


7. Temperature and time to pass the flow welding machine


Temperature and time to pass the flow welding machine must be strictly controlled. The recommended temperature is: preheating temperature 100 °C ± 5 °C, maximum not exceeding 120°C, and the preheating temperature rise is required to be stable, the welding temperature is 245°C ± 5°C. The time of welding is recommended not to exceed 3 seconds. After passed  the flow welding, avoid vibrating or impacting the LED until it returns to normal temperature. The temperature parameters of the wave soldering machine should be checked regularly, which is determined by the characteristics of the LED. The overheated or fluctuating temperature will directly damage the LED or cause LED quality hazard, especially for 3mm circular and oval LEDs.


8. Control cold solder


When the LED display does not light up, there are often more than 50% probability of various types of virtual soldering, such as LED pin soldering, IC pin soldering, pin rowing and soldering. Rigorous improvements in the process and enhanced quality inspections is required in improvements in these problems. The vibration test before leaving the factory is also a good test method.


return
Tel: +86 135 3053 5995 Skype
Email: sales@mydled.com 在线咨询

WeChat Scan, get FREE quote WeChat Scan, get FREE quote

在线咨询